MIMAKI TS34-1800A - Machine Settings Configuration

© 2011 MIMAKI ENGINEERING CO.,LTD.
4.2.1 P.1
1
2
3
4
5
6
7
8
R.1.0
4.2.1 [HEAD ADJUST] SLANT ADJUST
 Function
Makes mechanical adjustment of print head slant while checking the pattern. Make this adjustment when replacing
the head.
 Procedure
1. Move the adjusting lever to the right until the adjusting cam hits
it.
2. Select [SLANT ADJUST] from the operation menu to execute
adjustment pattern drawing.
3. Move the head over the platen using the JOG key.
Adjusting Lever
Adjusting Lever
<LOCAL. 1> [#01]
FUNCTION
#ADJUST <ENT>
#ADJUST
HEAD ADJUST <ent>
#HEAD ADJUST
SLANT ADJUST <ent>
#SLANT ADJUST
PRINT START :ent
[FUNCTION]
Adjustment pattern
drawing
#SLANT ADJUST
HEAD SELECT :12
MAINTENANCE MANUAL > Adjustment Items > Adjustment Function > [HEAD ADJUST] SLANT ADJUST
Model TS34-1800A Issued 2011.10.17 Revised F/W ver. 1.20 Remark
1.0
Rev.