© 2011 MIMAKI ENGINEERING CO.,LTD.
4.2.4 P.2
4.2.4 [HEAD ADJUST] DROP.POS
1
2
3
4
5
6
7
8
4. Carry out printing in order of [FINE-Y Si], [FINE-Y Re] and
[FINE-Y Bi].
After correcting the dot position of head 1 and 2 for FINE-Y Si
and FINE-Y Re, adjust Si and Re using head 1 only for Fine-Y
Bi.
[]/[]: Switches
5. Check the pattern.
Y Si, Y Re
Adjusting patterns of Head 1-2 is drawn successively.
Input the adjusting value of the D row of each head based on
the D row of the head 1.
(Use only the D row of each head for patterns)
Adjusting item: Head1-2,
Adjusting value: -50.0~ 50.0 dot (unit: 0.1 dot)
Y Bi
Input the impact position adjusting values of forwarding and
returning way.
Use only the D row of the head 1 for pattern drawing.
Adjusting item: Head1-1
Adjusting value: -50.0~50.0 dot (unit: 0.1 dot)
FINE Y Si, FINE Y Re
Input the adjusting value of the D row of each head based on
the D row of the head 1.
Use only the D row of each head for pattern drawing.
Adjusting item: Head1-2
Adjusting value: -50.0~50.0 dot (unit: 0.1 dot)
#DROP POS. HsLgDRFT
ADJUST :Y Si
:Y Re
:Y Bi
:FINE-Y Si
:FINE-Y Re
:FINE-Y Bi
#DROP POS. HsLgDRFT
Y Bi DRAW :ent
Pattern drawing
Even during the pattern drawing, the cap-in move-
ment will come in, which is not the completion of
pattern, therefore you have to be careful.
When opening the cover etc., do it after confirming
the drawing of a pattern of Head1-2 has been com-
pleted.
Adjustment Value
Return
Path
Outward
Path
R.1.0
MAINTENANCE MANUAL > Adjustment Items > Adjustment Function > [HEAD ADJUST] DROP.POS
Model
TS34-1800A
Issued
2011.10.17
Revised F/W ver.
1.20
Remark
1.0
To Next Page
Loading...
