© 2011 MIMAKI ENGINEERING CO.,LTD.
4.2.11 P.2
4.2.11 HEAD WASH
1
2
3
4
5
6
7
8
6. Clean inside the ink channels using washing liquid one more
time.
7. “Cap OFF” is carried out automatically and the print head
carriages move to the maintenance position. Then “Wiper ON”
is carried out automatically and the wipers are cleaned.
[ENTER]: To the next operation
8. Select the next operation.
[]: To the screen displaying the next operation
selection. (Step 10.)
[]: Filling of the transportation liquid
(Only at the factory shipment)
[]: Additional cleaning
9. Clean inside the ink channels using washing liquid.
10. Select the next operation.
[]: Head-wash completed (in this sequence)
[]: Discharge of the maintenance washing liquid
(To the next operation)
11. Remove the maintenance washing liquid cartridges and
discharge the liquid inside.
Set:WashingCartridges
12345678
* ABSORPTION *
00:00
Remove:Cartridges
12345678
* DISCHARGE *
00:00
Clean a Wiper.
COMPLETED :ent
END < > CONTINUE
V Re-WASH
Set:TRANS Liquid
12345678
* ABSORPTION *
00:00
Remove:TRANS Liquid
12345678
* DISCHARGE *
00:00
Maint.WashLiquid
END < > DISCHARGE
Remove:Maint.Wash
12345678
* DISCHARGE *
00:00
R.1.0
MAINTENANCE MANUAL > Adjustment Items > Adjustment Function > HEAD WASH
Model
TS34-1800A
Issued
2011.10.17
Revised F/W ver.
1.20
Remark
1.0
To Next Page
Loading...
