Use the Optional Ionizer
3
Clean with Electrode Probe Cleaning
Kit (SPA-0237)
Explain how to clean using Electrode Probe Cleaning Kit
(SPA-0237).
1
Soak the filter of electrode probe cleaning
kit for the cleaning unit in alcohol.
2
Cover the electrode probe cleaning kit ,
and gently turn two or three times.
• The filter of electrode probe cleaning kit wipes
away stains on the electrode probe.
• If it is very dirty, replace the filter and clean it
again.
Installing the Filter
Explain the filter exchange method of Electrode Probe
Cleaning Kit (SPA-0237).
1
Remove the used filter and insert the new
filter into the hole at the center of the
electrode probe cleaning kit.
• Be careful of the way the filter is facing. Install the
filter with the hole side up.
2
Push the filter all the way into the cleaning
kit.
• Mounting position of the filter to be set in ±1mm to
the end faces.
• Push the filter completely inside to prevent it from
bending.
• Do not touch the electrode probe directly. You
may get injured. Be careful to work.
• Do not touch the electrode probe with a hard
thing such as a tool. It may cause an accident or
failure of the machine.
Soak the Electrode Probe Cleaning Kit
• Lids are included with the
cleaning kit to prevent
dust from entering the
cleaning kit during
storage. Always put the
lids on when storing.
• Also, a cord can be
passed through the strap hole so that the kit can
be hung on a wall. Be sure to put on the lids during
this storage method as well. (Please prepare a
strap on your own.)
Cleaning Kit Replacement Filter
• After the filter is used to clean multiple electrode
probes, dust becomes attached to the filter and
the cleaning abilities are reduced.
• If the filter is dirty, replace with Electrode Probe
Cleaning Kit included instead filter or exchange
for optional cleaning kit of filters, (SPC-0238).
To Next Page
Loading...
