MIMAKI UJF-3042MkII - Clean the electrode inner wall; Installing Filter for SPA-0239 Cleaning Kit

Use the Optional Ionizer
4
Clean the electrode inner wall
Electrode Probe Cleaning Kit 2 (SPA-0239) is used to
clean the inner wall of the electrode probe cap.
When clean the tip of the electrode Probe, please use
Electrode Cleaning Kit (SPA-0237).
 Tools required for maintenance
• Electrode Probe Cleaning Kit 2 (SPA-0239)
• Goggles
• Alcohol
•Gloves
1
Soak the filter of electrode probe cleaning
kit 2 for the cleaning unit in alcohol.
2
Cover the electrode probe cleaning kit 2,
and gently turn two or three times.
• The filter of electrode probe cleaning kit 2 wipes
away stains on the electrode probe.
• If it is very dirty, replace the filter and clean it
again.
Installing the Filter
Explain how to replace the filter of Electrode Probe
Cleaning Kit 2(SPA-0239).
1
Remove the used filter and insert the new
filter into the hole at the center of the
electrode probe cleaning kit 2.
• Be careful of the way the filter is facing. Install the
filter with the diagonally tip side up.
2
Push the filter using tweezers all the way
into the electrode probe cleaning kit 2.
• Mounting position of the filter to be set between 0
to 2mm to the end faces.
• Push the filter completely inside to prevent it from
bending.
• Do not touch the electrode probe directly. You
may get injured. Be careful to work.
• Do not touch the electrode probe with a hard
thing such as a tool. It may cause an accident or
failure of the machine.
Filter
Cleaning Kit 2 Replacement Filter
• After the filter is used to clean multiple electrode
probes, dust becomes attached to the filter and
the cleaning abilities are reduced.
• If the filter is dirty, replace with Electrode Probe
Cleaning Kit 2 included instead filter or exchange
for optional cleaning kit of filters, (SPC-0240).
Filter
±1