For safe operation
6
Cautions on Installation
Firing and smoking
• Touching hot parts such as the LED UV with
combustible materials may cause firing and/or
smoking.
Leaving combustible materials under the LED
UV unit for a couple of minutes may also
cause firing and/or smoking.
• After this machine is used long time, foreign
materials or dust gathered may cause
electrical leakage, or insulation deterioration
may cause firing and/or smoking. Periodically
clean this machine and replace the
deteriorated parts after the insulation
resistance.
• After this machine is used long time, screws or
others on the conductive parts may be
loosened, causing firing and/or smoking.
Periodically tighten the screws.
• This machine is not an explosion-proof type.
Do not use the machine in a flammable
atmosphere. There is a danger of explosion.
• If abnormalities such as a strange odor, a
smoking or a spark burn occurred, turn the
power off and call our office immediately.
Periodic exchange parts
• There are some parts which must be
periodically replaced. Contract with
distributors or dealers for maintenance.
Adjusting the level
• Keep this machine horizontal.
Laser Module
CAUTION
• The printer incorporates a laser module.
The laser module is evaluates as Class 1
Laser Products.
• Use of controls or adjustments or performance
of procedures other than those specified
herein may result in hazardous radiation
exposure.
Laser Diode 655 - 660nm, max. 0.5mW
Maximum output : 0.12 mW
IEC60825-1: 2014
CAUTION
CAUTION
A place exposed to direct
sunlight
On an inclined surface
A place that vibrates
A place exposed to direct air
flow from an air conditioner or
the like.
A place where temperature or
humidity varies significantly
Around a place where fire
is used
•Use the machine under the
following environmental
conditions:
• Operating environment:
20 to 30 °C
(68 to 86 °F)
35 to 65 % (Rh)