Mimosa Backhaul Help Content
Mimosa Backhaul LED Status Indicators
Copyright © 2014 Mimosa Page 193
Off No Power to Device
Blinking Green (Slow) Device Booting / Rebooting
Blinking Green (Fast) Firmware Update in Progress
Solid Green Ready (Operational)
Blinking Yellow Update Failed (Invalid Firmware Image)
1
Solid Red After 10 seconds, Wiring Error or Boot Error
2
1
Please visit the Firmware page to download the latest image.
2
Please check wiring, cycle power, and then contact Mimosa Support if necessary.
Ethernet Status LED Table
The Ethernet Status LED indicates the negotiated port speed for the wired network connection. The device is
designed to perform best with a 1000BASE-T connection. While other port speeds are possible, they are not
recommended because they create a data bottleneck that reduces end-to-end throughput.
State LED Description
Off No Ethernet Connection
Solid Green 1000BASE-T
Blinking Green 1000BASE-T with Traffic
Solid Yellow 100BASE-T
Blinking Yellow 100BASE-T with Traffic
Solid Red 10BASE-T
Blinking Red 10BASE-T with Traffic
Wireless Status LED Table
The Wireless Status LED indicates a link between local and remote devices. The blink rate represents received signal
strength, which is useful while aiming the local device.
State LED Description
To Next Page
Loading...
Need help?
General
