2-2
2. LCD
Display infusion parameters and related contents.
3. <Menu Key>
Adjust the value and scroll up and down.
4. <Clear/Return Key>
In the editing status, press this key to set the parameter to 0.
When the edit value is 0, press this key to make the value return to the pre-edit
value.
In the non-editing status, press this key to return to the previous screen.
5. <OK Key>
Enter the editing status, determine the input operation and save the value.
6. <Start Key>
Install the syringe correctly, set the infusion parameters, and then press this key
to start the infusion.
In the Fast Forward Setup screen, after setting the fast forward parameter,
press this key to start automatic fast forward.
7. <Stop Key>
During the infusion process, press this key to stop the infusion. If the infusion is
stopped due to an alarm, such as blocking, etc., press this key to cancel the alarm.
8. <Fast Forward Key>
During the infusion process, press this key to enter the fast forward setup
screen.
In the non-operating status, press this key to enter the drainage prompt screen.
9. <Sound Pause Key>
Pause the alarm sound.
10. <Power Key>
Power on the equipment, enter the standby status and power off the equipment.
11. <Menu Key>
Enter the [Main Menu] screen.
In the operating status, long press this key to lock the equipment; after it is
locked, long press this key to unlock it.
12. AC/DC LED
On: The syringe pump has been connected to AC/DC power (Including
shutdown).
Off: The syringe pump is not connected to the AC/DC power supply.
13. Extender fixed block
Fix the extender.
To Next Page
Loading...