7-4
7. Click [Browse] and select the corresponding software in the corresponding
folder according to the software code of each product model corresponding to
[Scope of Application], as shown in the figure below.
8. After selecting the software, click [Upgrade] to start the upgrade. The upgrade
is completed. "Upgrade completed, please restart the pump” is displayed.
9. After the download is completed, “Main ExtFlash End upgrade” is also
displayed on the main unit, indicating that the download is completed. If there is
a red character in the upgrade status screen above, it indicates that the
download is unsuccessful. At this time, check all the connected equipment. If
“Main ExtFlash End upgrade” is not displayed on an equipment, the equipment
fails to download the software. Shut down the equipment and restart it.
Download the software again.
To Next Page
Loading...