System Preparation 3-13
a) Download the ppd file from the printer manufacturer’s official website
(contact service engineer if necessary), and copy the ppd file to the storage
device (USB disk as an example).
b) Connect the USB disk to the ultrasound system, click [Setup]Æ[Print Preset]
”Printer Driver”Æ[Add Printer] to run the ppd file and finish the installation.
NOTE: All printer drivers integrated in the ultrasound system come from official website
of each printer manufacturer (you can check models in the [Setup]Æ[Print
Preset]Æ”Printer Driver”Æ[Printer Supported ]).Printer drivers may not be
updated in time due to software version and region limitation, consult printer
manufacturer for details.
3.6.3.2 Add Network Printer
1. Make sure the target network printer and the ultrasound system are both connected
into the same LAN.
2. Check the IP address of the network printer (for details, please refer to the
accompanying documents of the printer).
3. Enter [Setup]Æ[Print Preset]Æ”Printer Driver” page, click [Add Printer] to enter the
screen, type in the IP address of the network printer. (Port is 9100 in default).
4. Click [Verify Net Printer], the IP address, name and port information of the network
printer will be displayed under the “Port” box. Change the port to match the verified
printer information if necessary.
5. Click [OK] to enter the ppd installing screen:
z Select PPD file from media: select the path from the external media and install.
z Select PPD file from database: select the ppd. file integrated in the ultrasound
system.
6. After the ppd. file is installed completely, enter the printer name to finish the
installation.
7. After installation succeeds, the system returns to the “Printer Driver” page and
displays the added network printer.
3.6.3.3 Installing a Wireless Printer
The system supports wireless graph/text printer for report printing.
1. Plug the printer power cord into an appropriate outlet.
2. Power the system and the printer on.
3. Make sure the ultrasound machine and the printer are connected to the same LAN,
and turn the printer's W-LAN function on.
4. Add a wireless adapter, following the steps described in “Add network printer.”
5. Open the [Setup]Æ[Print Preset] page, select “Report Print” from the printer list,
select the printer to be the wireless printer, and set properties.
6. Click [Save] to exit the preset and make the settings effective.
3.6.3.4 iStorage UltraAssist Print
The system supports printing by iStorage function. Before using this function, please make
sure that the iStorage server has configured a defaulted printer, and the ultrasound
system has configured an iStorage server. For details, please refer to “12.5.2 iStorage”.
1. Enter [Setup]Æ[Print Preset]Æ”Printer Driver” and check iStorage printer status,
which should be AssistPrinter@IP address with “Ready” status.
To Next Page
Loading...
