EasyManuals Logo
Home>Mindray>Diagnostic Equipment>DP-18

Mindray DP-18 User Manual

Mindray DP-18
129 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #16 background imageLoading...
Page #16 background image
X
WARNING:
17. Before moving the system, power it off, close the control
panel and then remove all connections (including
connections to transducers). Then hold the system’s
handle to move the system to a proper location carefully.
18. Before cleaning the system, power it off and remove the
power plug from the receptacle to avoid electric shock.
19. To avoid system damage or electric shock, do not remove
the power plug from the receptacle before turning off the
system.
20. To avoid equipment damage or electric shock, do not
remove the power plug from the receptacle before turning
off the peripheral.
21. To avoid system or printer damage or electric shock, do
not connect/disconnect printer’s data cable before turning
off the system and printer.
22. Accessory equipments connected to the system’s
analogue and digital interfaces must be complied with the
relevant IEC standards (e.g., IEC 60950 Information
Technology Equipment standard and IEC 60601-1 Medical
Electrical Equipment standard). Furthermore all
configurations should comply with the standard
IEC60601-1-1. Everybody who connects additional
equipment to the signal input part or signal output part
configures a medical system, and is therefore responsible
that the system complies with the requirements of
IEC60601-1-1. If in doubt, consult our company’s Customer
Service Department or your local distributor.
23. Use ultrasound gel complying with local regulations.
24. This system is not intended for ophthalmic use.
CAUTION:
1. This manual does not describe clinical examination
techniques. Selection of proper clinical examination
technique must be based on specialized training and
clinical experience.
2. There is no risk of high-temperature burns during routine
ultrasound examinations. To prevent high-temperature
burns, do not apply the transducer to the same spot on the
patient for a long time. Apply the transducer only for as
long as required time for diagnosis.
3. Ensure the system date and time are consistent with
current date and time. If they are not consistent,
misdiagnosis may occur.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Mindray DP-18 and is the answer not in the manual?

Mindray DP-18 Specifications

General IconGeneral
BrandMindray
ModelDP-18
CategoryDiagnostic Equipment
LanguageEnglish

Related product manuals