XII
9. Only engineers of our company or authorized by our company
can replace the fuses.
10. Only perform operations described in this manual.
11. Do not modify system parameters. If it is necessary to change
system parameters, contact our company’s Customer Service
Department or your local distributor.
12. Deterioration of electrical and mechanical safety characteristics
(such as generation of a leakage current or
deformation/abrasion of mechanical parts) and of image
sensitivity and precision may occur over a period of time. Check
and maintain the system periodically. To ensure system
performance, it is recommended to sign a maintenance and
service contract to avoid accidents and misdiagnosis.
13. To dispose of the system or any part, contact our company’s
Customer Service Department or your local distributor first. Our
company does not assume any responsibility for damage
resulting from disposal of the system without consulting our
company.
14. When using this system with portable package, be careful not to
block the ventilation slots.
15. Do not use a USB memory device (e.g., a USB flash drive,
removable hard disk) which has unsafe data. Otherwise system
damage may result.
Please read the following precautions carefully to ensure the safety of the patient and the
operator when using the probes.
WARNING:
1. This ultrasonic probe is only for use with the specified
ultrasonic diagnostic system. Please refer to “A.3
Optional Transducers” to select the proper probe.
2. Confirm that the probe and cable are normal before and
after each examination. A defective probe may cause
electric shock to the patient.
3. Do not subject the probe to shock. A defective probe may
cause electric shock to the patient.
4. Do not disassemble the probe to avoid the possibility of
electric shock.
5. Never immerse the probe connector into liquids such as
water or disinfectant because the connector is not
waterproof. Immersion may cause electric shock or
malfunction.
6. Ultrasonic probe is only for use with the specified
ultrasonic diagnostic system. Please refer the ultrasonic
diagnostic system operation manual to select the proper
probe.
7. A probe sheath must be installed over the probe before
performing intra-cavity or intra-operative examination.
To Next Page
Loading...
