Mindray M9Vet - Security

3-32 System Installation
The DICOM Service Setting is used to set properties of DICOM services. See the basic volume for
details.
Note:
Only if DICOM basic option is configured, Worklist page is available.
3.6.8 Security
Click [Security] on the Setup menu to enter the security-setting screen.
1. Drive Encryption/Secure Data Wipe
Encrypt the patient data stored in the hard disk. The system provides two encryption methods:
Factory Default and User Define.
 Factory Default: the system is in factory state by default.
 User Define: add a user-defined password.
1) Select [User Define]. If the patient data are already stored in the hard disk, the system prompts
the following message: (if no patient data are stored in the hard disk, perform steps 5 to 6
directly)
2) Click [OK] to return to the Security screen, click [Wipe], and the system prompts the following
message: