Image Optimization 5-47
Parameter Description
Contrast
Function: set the contrast scale of the image (contrast).
As long as the contrast becomes larger, the bright spot and dark spot on the image
change as well.
Range: 0%-100%, in increments of 2%.
NOTE: the adjustment for 3D (VR) and MPR
Tint
Function: enable/disable tint map. The color of image changes according the tint
value.
Selection: OFF, 1-8.
Quick
Rotation
Function: to rotate the 3D image quickly.
Range: 0°, 90°, 180°, 270°.
3D iClear
Function: Use the 3D self-adaptation filter to strengthen the space continuity of the
tissue structure, and provide speckle noise suppression, and improve the image
contrast effect, so as to optimize the volume image data.
Selection: OFF, 1-7.
Select VR image. Adjust 3D iClear to optimize VR image.
Select MPR image. Adjust 3D iClear to optimize MPR image.
Face+
Optimize the signal of the face area to reduce the noise of the AF area and improve
the signal-noise ratio of the face area, make the face more fullness to easily obtain
the image of fetal face.
Range: O F F, 1-3.
VR Refine
Function: Optimize the signal-noise ratio and the contrast of VR image.
Selection: OFF, 1-7.
MagiClean
Function: Reduce the noise and keep the boundary of the image more clearly.
Selection: Off, Low, Mid, High and Max. Available only in Surface rendering mode.
Depth VR
Function: Superimpose the tint map basic on the VR image to improve the
stereoscopic sensation and the contrast of the image.
Selection: Off, Black, Cyna, Blue, Rose
Hyaline
Function: Improve the transparency in iLive rendering mode to observe the tissue,
such as cyst.
Adjust method: Click [Hyaline] under iLive render mode, the merging ratio of two
render modes between Hyaline and iLive is 100%; or, rotate the knob under [Hyaline]
and adjust hyaline range.
Effect: Adjust the merging ratio of two render modes between Hyaline and iLive
Thickness Selection: 0-30mm.
Reset Curve
Parameter Description
Reset
Ori
To reset the volume rotation, shifting and zooming of 3D image
to original status.
Reset All
To reset the parameters, rendering rotation, VOI and image
effect.
Reset Curve To reset the curve to be the original beeline.
To Next Page
Loading...
