Mindray Nuewa I9 - Page 167

Image Optimization 5-93
Operation Rotate the knob under the [Map] item on the touch screen or adjust through the
mapping-menu item to select the map.
The system provides 6 maps, including 1 grayscale map and 5 color maps.
Strain mode
Description Affect the display effect of adjusting dynamic range.
Operation Tap [Strain mode] on the touch screen to adjust the parameters.
Impacts
Strain mode is set to 0, adjust dynamic range, the image difference changes
obviously.
Dynamic Range
Description Adjusts contrast resolution of an image.
The real-time dynamic range value is displayed on the image parameter area in the
upper left corner of the screen.
Operation
Rotate the knob below [Dyn Ra] to adjust the parameters.
Impacts
The more the dynamic range, the more specified the information, and the lower the
contrast with more noise.
Sensitivity
Description
Increase the image palpability.
Operation
Rotate the knob under the [E Sensitivity] item on the touch screen to adjust the value.
Impacts The higher the sensitivity, the higher the image palpability.
Strain Scale
Description
Adjust the bar height of the pressure hint curve to keep the average height of the
hint bar on proper position.
Operation
Rotate the knob under the [Strain Scale] item to adjust.
Map Position
Description
This feature is used to adjust the up/down position of the map.
Operations
Tap [Map Position] on the touch screen to adjust the parameter.
Effects
When the E Average function is enabled or disabled, the elasto curve is displayed
based on different statistical amounts.
5.14.1.5 Mass Measurement
Press <Measure> to enter measurement status.
You can measure shell thick, strain ratio, strain-hist, etc.
For details, see [Advanced Volume].