13-44 Probes and Biopsy
3. Rotate the clamping nuts of the needle guided-bracket on right and left side (following the direction
of the arrow). The needle guided-bracket is separate from the transducer. Hold the transducer and
take out the bracket.
NGB-039
(1) Hold the probe and press the pressing block to separate V-shaped guiding block from the
pressing block.
(2) Remove the needle.
(3) Rotate the clamping nut to separate the bracket from the probe.
NGB-047
Hold the prober in the left hand; unscrew the locking nut with the right hand to loose the clamp
(arrow’s direction). Lift the biopsy up (towards arrow’s direction). The locating pole, front clamp, the
locating hole and the front clamp become loose.
To Next Page
Loading...
