Description of Self Test Items C-19
C.1.44 Z1601 TRC Slot ID Test
Top test item
TRB Slot ID Test
Test Content
Check whether TRC is in the place, and then read the slot ID of TRC board (the slot ID of TR64
can be set via the mother board).
Analysis to Test Failure
The drive goes wrong if the test result appears Error.
The error for slot ID of TRC board occurs if the test result is FAIL.
Suggestion to Test Failure
Restart the device to perform the self test if the test result appears Error. It is necessary to restore
the device if Error re-appears.
If the test result is FAIL, replace the TRC first, and then replace the mother board.
C.1.45 Z1602 TRC XCVR Bus Test
Top test item
TRC Slot ID Test,PC Module and DSP FPGA Interconnection Test
Test Content
Test whether the control bus communication between DSP FPGA and XCVR of TRC FPGA works
well via reading the register.
Analysis to Test Failure
The drive goes wrong if the test result appears Error.
The connection error between DSP FPGA and TRC FPGA occurs if the test result is FAIL.
Suggestion to Test Failure
a) Restart the device to perform the self test if the test result appears Error. It is necessary to
restore the device if Error re-appears.
b) It is recommended to change TRC board if the test result is FAIL.
C.1.46 Z1603 TRC DDRIII (DIMM) Test
Top test item
TRC XCVR Bus Test
Te s t C o n tent
Read and write on the memory of the TRC and judge whether the data for the write and the input
are the same.
Analysis to Test Failure
The drive goes wrong if the test result appears Error.
The connection error between FPGA and the memory occurs if the test result is FAIL.
To Next Page
Loading...
Need help?
General
