C-20 Description of Self Test Items
Suggestion to Test Failure
a) Restart the device to perform the self test if the test result appears Error. It is necessary to
restore the device if Error re-appears.
b) If the test result is FAIL, it is recommended to check the TRC on the engine board.
C.1.47 Z1701 CW Board Position Test
Top test item
TRB Slot ID Test,PC Module and DSP FPGA Interconnection Test
Test Content
Check whether CW board is installed on the TRB.
Analysis to Test Failure
No CW board on the TRB board or on three boards (the TRA/TRB/TRC boards) at the same time
if the test result is FAIL.
The CW board is not detected on the TRA/TRB/TRC boards if the test result is NaN.
Suggestion to Test Failure
The CW board should be installed on TRB. The test result will show the CW board position. Adjust
the installation of the CW board based on the test result.
Check if the CW board on the TRB board when the test result is FAIL.
a) The CW board on the TRA or TRC board is not stratified if theTRB board has no CW board.
b) No CW board on the TRA and TRC board at the same time if the TRB board has the CW
board.
C.1.48 Z1702 CW Board SPI Interface Test
Top test item
CW Board Position Test
Test Content
It is able to receive the data for CW mode.
Analysis to Test Failure
The drive goes wrong if the test result appears Error.
The CW board interface goes wrong if the test result appears FAIL.
Suggestion to Test Failure
Restart the device to perform the self test if the test result appears Error. It is necessary to restore
the device if Error re-appears.
It is recommended to change CW board if the test result is FAIL.
C.1.49 Z1801 CPU Temperature Test
Top test item
N/A
Test Content
With the test software accelerating the workload, monitor whether the CPU temperature can meet
the standard in 5 minutes. Click <Terminate Testing> to finish the test in the process.
To Next Page
Loading...
Need help?
General
