Panorama® Service Manual 0070-10-0634 2 - 27
Repair Information Assembly Instructions
If a drive has been replaced, you must create a new Array.
a. Simultaneously press the Ctrl and F keys. The Main Menu appears.
FIGURE 2-14 FastBuild Utility Main Menu
b. Press [ 1 ] Auto Setup. The Auto Setup Options Menu appears.
FIGURE 2-15 Auto Setup Options Menu
c. Simultaneously Press the Ctrl and Y keys to save. If the Array has been successfully
created, a message appears in the center of the Array Setup Configuration screen.
FIGURE 2-16 Array Setup Configuration Screen
After the array is successfully completed, it still must be formatted and configured.
FastBuild ? Utility 1.3 ? 1996-00 Promise Technology, Inc.
[ Main Menu ]
[ 1 ]
[ 2 ]
[ 3 ]
[ 4 ]
[ 5 ]
[ 6 ]
Auto Setup
View Drive Assignments
Define Array
Delete Array
Rebuild Array
Controller Configuration
FastBuild ? Utility 1.3 ? 1996-00 Promise Technology, Inc.
[ Auto Setup Options Menu ]
Optimize Array for: Performance
Typical Application to use: Desktop
[ Array Setup Configuration ]
Mode
厖厖厖厖厖厖厖厖厖厖
Stripe
Spare Drive
厖厖厖厖厖厖厖
?
厖
.0
Drives(s) Used in Array
厖厖厖厖厖
??..2
Array Disk Capacity (size in MB)
厖厖厖
...
厖
152638
FastBuild ? Utility 1.3 ? 1996-00 Promise Technology, Inc.
[ Auto Setup Options Menu ]
Optimize Array for: Performance
Typical Application to use: Desktop
[ Array Setup Configuration ]
Mode
厖厖厖厖厖厖厖厖厖厖
Stripe
Spare Drive
厖厖
Array has been created
<Press Any Key to REBOOT>
Drives(s) Used in A
厖厖厖厖厖
??..
Array Disk Capacity (size in MB)
厖厖厖
...
厖
52638
To Next Page
Loading...
