F3Ci Service Manual
_______________________________________________________________________________________________________________________
12
3. Disassembly & Reassembly Procedures
a. This section describes the procedures required to exchange line replaceable units.
Whenever a unit is replaced, mechanical and functional testing as described in Section 2 -
Mechanical & Functional Testing must be completed.
b. It is recommended that the 3004-0055 F3Ci service tool kit be used to conduct
disassembly and reassembly procedures. The tool kit contains the following:
• Pull-through for coil cable
• Flat blade screwdriver
• 3mm hex key driver
• 2.5mm hex key driver
• 2mm hex key driver
• T20 Torx driver
• 18mm spanner
• 13mm spanner
• 10mm spanner
• 3mm pin punch
• Screwdriver Pozidrive No 1
• Screwdriver Pozidrive No 2
• Tube Spanner 7/8
• Silicone grease
To Next Page
Loading...
Need help?
General
