30 31
The GPX-4000 is provided with a Factory Preset
selection of menu settings, suitable for first-time
users.
Until you become more familiar with the
GPX-4000, the detector can simply be operated with
the Factory Presets and the front panel controls.
To restore all Factory Preset settings:
1 Turn the detector off.
2 Press and hold On/ Off until the Reset Defaults
menu appears (approx. 5-6 seconds).
3 Turn Function Select to the right to select All
Settings, as shown on the diagram.
4 Turn Setting left or right to restore all Factory
Presets.
To restore Factory Preset settings for the
current search mode:
1 Turn the detector off.
2 Press and hold On/ Off until the Reset Defaults
menu appears (approx. 5-6 seconds).
3 Turn Function Select to the right to select the
current mode. The current mode is dependent on
the mode switch on the front panel.
Note: If the
displayed mode is not the one you wish to restore
you must change the mode on the front panel.
4 Turn Setting left or right to restore Factory
Preset settings for that mode.
Function
Select
Setting
On/Off
Hold for FP
FP
Function
Select
Setting
On/Off
Hold for FP
Factory Presets
Main Menu: Range: Factory Preset:
Volume Limit 1 to 40 25
Audio Tone 1 to 100 50
Signal Peak 1 to 20 15
Track Speed Slow
Medium
Fast
Medium
GB Type General
Specific
General
Sensitive Extra
Smooth
Smooth
Iron Reject Off (All Metal)
1 to 30
Off (All Metal)
Battery Volts - -
Manual Tune 0 to 255 -
Mode Edit: General: Patch: Deep:
Audio Quiet
Normal
Boost
Deep
Normal Boost Deep
Gain 1 to 15 879
Motion Very Slow
Slow
Medium
Fast
Slow Medium Very Slow
Response Normal,
Inverted
Normal Normal Inverted
To Next Page
Loading...
