Minelab X-Terra 705 - Page 14

The Preset Discrimination Patterns may be
edited to create custom patterns.
Method 1 – to reject a specic
Target ID using an actual target
When a target is detected a discrimination
segment will ash, indicating its position on
the discrimination scale, and the target’s ID
number will appear on the LCD.
Press Accept/Reject
to reject that
Target ID.
The discrimination segment and
icon will
appear to indicate that the detected ID is now
rejected.
Check that the Target ID has been rejected
by detecting again. There should be no audio
response (blanking) from that target
(Detector Audio, p. 17).
Method 2 – to reject a specic
Target ID using + or –
Use + and – to scroll through and select the
Target ID you want to modify. The ashing
segment and the Target ID number will
indicate the selected ID.
Press Accept/Reject
to either accept or
reject that ID. The discriminated segment and
the
icon will appear if rejected. The segment
and the
icon will disappear if accepted.
Accept/Reject toggles between
accepting and rejecting targets.
All Metal Shortcut
The X-Terra 705 has
an All Metal shortcut
available in both modes.
In Coin & Treasure Mode,
press All Metal
to
toggle between the
selected Pattern and
All Metal.
Pattern
Discrimination
In Coin & Treasure Mode
use Patterns
to
toggle between
Pattern 1, Pattern 2,
Pattern 3 and Pattern 4.
Iron Mask
Discrimination
In Prospecting Mode
use
+ and – to
adjust the Iron Mask
Discrimination scale.
The All Metal Pattern
cannot be edited.
In Prospecting Mode,
press All Metal
to
toggle between Iron
Mask and All Metal.
When the Iron Mask Level is set to 0,
the detector behaves the same as in
All Metal Pattern.
25
editing a discrimination pattern
24
choosing a discrimination pattern