31
CONTENTS
This Advanced Setting allows you to manually
control the point at which ferrous tones
occur. A use-case example of this is coke, an
undesirable non-ferrous 'pest' target that
typically has a Target ID of 1 or 2, though it can
go as high as 4.
By moving the ferrous tone break point up to 4 (segment 6
on the Discrimination Scale), coke is moved into the ferrous
range and will now give a ferrous response. Note however
that some low conductive targets will now give the same
response as a 'bad' ferrous target.
By default, Target IDs –19 to –4 are set as ferrous for Park
and Field Modes, and –19 to 0 are set as ferrous for Beach
Mode.
Tone Break adjustment is local; only the current Search
Mode Profile is affected by changes to this Advanced
Setting.
Tone Break is not available when Target Tone is set
to 1 Tone.
ADJUST TONE BREAK
Before adjusting Tone Break, select your preferred
Target Tones setting (page 29).
This is because changes to Tone Break only apply
to the active Target Tone setting.
X-TERRA PRO allows the ferrous break point to be adjusted.
1. Navigate to the Accept/Reject setting.
2. Long-press (2 seconds) the Settings button to select
the Tone Break Advanced Setting.
(2 Seconds)
3. 't1' will appear on the Frequency Display. The
Target ID Number will show the current value of the
ferrous tone break point, (e.g. 0), and the corresponding
Discrimination Segment will flash slowly.
4. Use the Minus (–) and Plus (+) buttons to navigate to the
Discrimination Segment you wish to use as the ferrous
tone break point.
Tone Break (Advanced Setting)
To Next Page
Loading...
Need help?
General
