CMR CARD
18.2 SP1
BC_GB18
18-1HOW TO REPLACE THE CARD DRIVE OF D.C. MOTORS
1) Cut out the power by means of main switch QS on the electric cubicle.
2) Open the door of the electric cubicle after unscrewing the screws and free the access to the card arranged in the
electric box.
3) Take off the card from the 4 plastic supports by bending the locking tooth: we recommend to use a small plastic
pipe of proper diameter (e.g. a body pen see fig. 18.1).
4) Withdraw the 3 connectors present on the card.
5) Connect the new card according to the wiring diagram, fasten the card to the door of the electric box, shut it to put
the machine under voltage.
6) If the correct spare card is used no other adjustment is necessary; otherwise carruy out the instructions attached
where operation and methods of adjustment of the cards is fully explained
To Next Page
Loading...