MINN KOTA PowerDrive User Manual

12 | minnkotamotors.com
©2023 Johnson Outdoors Marine Electronics, Inc.
INSTALLING THE POWERDRIVE
l. Place a Flat Washer (Item #2) and then a Nylock Nut
(Item #3) at the end of each screw as shown and
secure. Make sure all hardware is secure.
ITEM(S) NEEDED
#2 x 6
#3 x 6
Screw
Rubber WasherRubber Washer
Boat DeckBoat Deck
Nylock Nut
Flat Washer
NOTICE: To prevent seizing of the stainless steel
hardware, do not use high speed installation tools.
Wetting the screws or applying an anti-seize may
help prevent seizing.
8
k. Put a 1/4-20 x 3-1/2" (Item #1) Screw in each of the
drilled locations. The Screw should pass through
the Base Extrusion and the boat deck. If the Rubber
Washers (Item #4) are used, they should sit between
the Base Extrusion and boat deck. Make sure to
secure the motor with screws on each side of the
Base Extrusion.
ITEM(S) NEEDED
#1 x 6
#4 x 6
Screw
Rubber WasherRubber Washer
Boat DeckBoat Deck
7

MINN KOTA PowerDrive Specifications

General

Type	Electric Trolling Motor
Steering	Electric
Control	Foot pedal or wireless remote
Voltage	12V or 24V
Mount	Bow
Speed Control	Variable
Digital Maximizer	Yes
Battery Requirement	12V or 24V deep cycle marine battery
Shaft Length	36", 42"
AutoPilot	Optional
i-Pilot Link	Optional