16
CHANGING BATTERIES
Insert the batteries.
• Make sure the positive and negative
battery terminals are orientated as
illustrated on the diagram in the battery
chamber.
This digital camera uses four AA-size alkaline batteries. AA-size Ni-MH batteries can also be used,
and are recommended because of longer life. When using Ni-MH batteries, fully recharge them with
a battery charger suitable for complex electronic equipment. Please consult your vendor about an
appropriate charger.
When replacing batteries, check that the mode dial is in the off
position.
Close the battery-chamber door and slide it back toward the body (4) to
engage the safety catch. Move the lock lever (5) to the close position
.
• After installing the batteries, the set-time/date message may appear
an the monitor. Reset the clock and calender in the custom 2 section
of the setup menu (p. 84).
Open the battery-chamber door by moving the battery-chamber lock (1)
to the open position . Slide the door forward (2) to release the
safety catch; the door should spring open (3).
1
2
4
3
5
GETTING UP AND RUNNING
To Next Page
Loading...
