ii
DA high voltage is being applied to the part marked with the symbol shown
on the right. Touching it can cause an electric shock. Be sure to unplug the
power cord when servicing this part or other parts near it.
DWhen the machine is energized with any of its covers removed, never use a flammable spray near it,
as a fire can result.
DMake sure that correct screws (diameter and length of the screw, binding/tapping screws) are used in
the correct places when assembling parts. If a wrong screw is used, a short insulating distance could
result.It couldalsoresult incollapsedthreads,whichprovidesonlyapoorgroundingconnection,result-
ing in an electric shock.
DAtoothedwasherandspringwasher,ifusedoriginally,mustbereinstalled.Iftheyareleftout,acontact
failure results, causing an electric shock or fire.
DReplace a lithiumcell onlywith one havingthepartnumberspecified in the partsmanual. Anexplosion
could result if the cell is installed with wrong polarity or a wrong cell is installed.
Disposeof ausedlithium cellaccordingtotheapplicablelocalregulations.Neverthrowitawayoraban-
don it on the user’s premises.
Caution
!
u Other Precautions u
DWhile the machine is being energized, do not unplug or plug in a connector on a PWB or relay harness.
DSincethe MagnetRollerof theImagingUnit generatesastrongmagneticforce,donotbringaCRT,watch,
floppy disk, or magnetic card near it.
DUseofanairgunorvacuumgeneratesstaticelectricitywhichcancausetheATDCSensorandassociated
parts to break down. Be sure therefore to use a blower brush or cloth to clean these parts. If a unit is to
be cleaned, be sure to remove the sensors in advance.
DMOS lCs are susceptibleto static electricity. When handlingaPWB loaded withMOS ICs, followprecau-
tions given in “INSTRUCTIONS FOR HANDLING THE PWBs WITH MOS ICs.”
DThePC Drumishighly delicate.Whenhandling thePCDrum, followtheprecautionsgiven in“HANDLING
OF THE PC DRUM.”
DTo reassemble, reverse the order of disassembly unless otherwise specified.
DNote that replacement of a PWB may call for readjustments or resetting of particular items.
CAUTION: DANGER OF EXPLOSION IF BATTERY IS INCORRECTLY REPLACED. REPLACE
ONLY WITH THE SAME OR EQUIVALENT TYPE RECOMMENDED BY THE MANUFACTURER.
DISPOSE OF USED BATTERIES ACCORDING TO THE MANUFACTURER’S INSTRUCTIONS.
ADVARSEL!:Lithiumbatteri - Eksplosionsfare ved fejlagtig håndtering. Udskiftning må kun ske med
batteri af samme fabrikat og type. Levér det brugle bafferi tilbage til leverandoren.
To Next Page
Loading...
