Load the originals so that the punched holes in them are located as shown below.
Note the correct direction of the originals if the copies are to be punched using Hole Punch.
Using the Automatic/Duplexing Document Feeder
Load the originals so that the punched holes in them are located as shown below.
Correct:
Placing the Original on the Glass
Correct:
Hole Punch is possible only when your copier is equipped with a 20-Bin Staple Sorter.
NOTE
1149O089DA
Punched Hole Position
Originals
Copies
Punched Hole Position
Original
Copy
1149O092EA
Chapter 3
Making Copies
6. Finishing Mode
55
To Next Page
Loading...
