Minolta EP4000 - Placing Originals on the Original Glass

Different methods are used to place the original depending on its type. Use the appropriate
procedure.
Placing Originals on the Original Glass
Sheet Originals
Raise the Original Cover and place the
original face down on the Original
Glass.
1
Align the rear left corner of the
original with the marker on the
Original Width Scale. Then, press the
rear edge of the original up against the
Original Positioning Plate at the rear
side of the Original Glass.
2
Gently lower the Original Cover.
3
Place a blank sheet of paper of the
same size as the original over the
original.
2
Highly Transparent Originals
(Using transparencies and translucent paper for
the original)
Place the original in the same way as
the sheet originals.
1
Gently lower the Original Cover.
3
1134O112AA
1134O113AA
Original Positioning
Plate
1134O060AA
1134O114AA
Blank Sheet
of Paper
The original size that can be detected
in the Auto Paper Select Mode are
A3L, B4L, A4L, A4C, A5L.
When making copies from originals
other that the above, select the copy
paper size.
When using wrinkled or curled
originals, the original size might not be
detected correctly. So, select the copy
paper size and do not use the Auto
Paper Select Mode.
Copy Paper Size ➭ p. 34
NOTES
Chapter 3
Making Copies
2. Placing Originals
29