• When flash is charged, flash-ready signal
on 3200i will ~w/and flash-ready signal in
camera's viewfinder will blink slowly.
• Shutter speed and aperture will be
displayed in the viewfinder and data panel of
7000i.
2. For autofocusing, press and hold shutter-
releasebutton partway down.
• If the camera's focus signals indicate that
autofocusing is not possible, set camera to
manual focus mode and focus manually.
• If the AF illuminator is lit, focus will not
be adjusted continuously.
3. After focusing, check whether main
subject is within the flash range for the film
speed in use. Flash ranges for ISO 100 are
listed in the TECHNICAL DETAILS.
4. To take a picture, press the shutter-
releasebutton all the way down.
• After taking a picture, the flash-ready
signal in the viewfinder will blink rapidly if
exposure was sufficient.
• If the shutter will not release, set camera
to manual focus mode, focus manually, and
releasethe shutter.
• If 7000i is set to shutter-priority (S)
mode, operation is the same as in program
mode.
To Next Page
Loading...
Need help?
General
