6
3. CAMCORDER OPERATION
Once you have inserted the MicroSD memory card and plugged your camcorder into a power
source, your camcorder will automatically power on. You may also manually power your
camcorder on or off by pressing the POWER button for 3 seconds.
There are 3 operation modes available for use. To cycle through the different modes, simply
short press the POWER / MODE button. Your camcorder’s screen will show the current mode
in the display’s upper left corner. Modes cannot change while a video is being recorded.
The recording must stop first before changing to another mode.
3.1 Video Capture Mode
Once your camcorder powers on, it will default to Video Mode and will begin recording
automatically. To start or stop recording at any time, press the OK button. To manually
capture video when changing from another capture mode, enter VIDEO Mode and press the
OK button to begin recording video again.
3.2 Photo Capture Mode
To capture a photo, enter PHOTO Mode by short pressing the POWER / MODE button until a
camera icon is show in the upper left hand corner of the screen. Press the OK button to
instantly capture a photo. You may also capture a photo during a video recording by pressing
the UP button.
3.3 Playback Mode
To review your video and photo files, enter PLAYBACK Mode. Short press the POWER /
MODE button until a previously captured file is shown on the screen. The most recent file
captured will be displayed first.
• Press the UP and DOWN buttons to cycle through available playback files of photos and
videos.
• To delete a file or to protect a file from deletion, press the MENU button.
• Press the POWER / MODE button again to exit PLAYBACK mode.
Playing Back Video Clips
• Press the OK button to play or pause a video clip in PLAYBACK mode.
• To delete a file or to protect a file from deletion, press the MENU button.
To Next Page
Loading...
