4
SAFETY : WARNINGS
1.Warning!
1.1. This shower can deliver scalding temperatures if not operated, installed or
maintained in accordance with the instructions, warnings and cautions contained
in this guide and on or inside the appliance.
1.2. THIS APPLIANCE MUST BE EARTHED. MAKE SURE SUPPLEMENTARY
BONDING COMPLIES WITH THE “REQUIREMENTS FOR ELECTRICAL
INSTALLATIONS”.
system with its own dedicated supply.
1.3. DO NOT twist the individual cable cores of the live and neutral conductors, as
this will prevent them from entering the terminal block.
1.4. The shower unit must NOT
insulated.
1.5. DO NOT
1.6. If the cover is removed, the following warnings must be observed:
1.6.1. Turn off the electrical and water supplies before removing the cover.
1.6.2. Mains connections are exposed when cover is removed.
1.6.3. Refer to the wiring diagram before making any electrical
1.6.4. Ensure all electrical connections are tight, to prevent them
overheating.
2. Caution!
2.1. Follow all warnings, cautions and instructions contained in this guide, and on
or inside the appliance.
2.2.
supply company in force at the time of the installation. The installation should be
registered, or is a member of an association such as:
2.2.1.
2.2.2. The Electrical Contractors Association (ECA), England and Wales.
2.2.3. The Electrical Contractors Association of Scotland (ECAS).
To Next Page
Loading...
