8
Feed the hose through the retaining ring and screw to both the showerhead
and shower unit. Use the washers supplied to seal the connections. Place the
showerhead assembly into the clamp bracket assembly and check the operation.
Turn the water supply back on.
Switch electrical supply on.Turn power control to low.
Turn temperature control to full cold.
Commissioning
1 2
Follow this procedure to check the function and performance before using the shower for the
rst time. Make sure that all users are familiar with the operation of the shower. This
guide is the property of the homeowner.
Showerhead
Assembly
Clamp Bracket
Assembly
To Next Page
Loading...
