Mira Select Flex - Page 18

18
RAC Backplate
Backplate
Screws
22. Check that the blue ‘O’ seal is tted inside the
backplate nut. Fit the olive and the backplate
nut over the outlet pipe and tighten the nut.
23. Check that the second ‘O’ seal (black) is tted
to the outside of the backplate nut. Press
the elbow onto the backplate, make sure
that the clips on the elbow engage with the
backplate.
24. Press the shroud over the elbow, make
sure that it engages with the lugs on the
backplate.
Backplate Nut
Olive
Elbow
Shroud
25. This completes the installation of the RAC
assembly, fit the concealing plate and
control assembly. Refer to section: ‘Control
Assembly’.