Need help?Do you have a question about the Mircom TX3-2000-8U-C and is the answer not in the manual?
General| Model | TX3-2000-8U-C |
|---|---|
| Type | Intercom System |
| Number of Stations | 8 |
| Operating Voltage | 24 VDC |
| Frequency Response | 300Hz - 3.4kHz |
| Humidity | 0-95% non-condensing |
| Current Consumption | 500mA |
| Display | LCD |
| Connectivity | TCP/IP |
| Directory | Electronic directory |
| Mounting | Wall Mount |
Describes the TX3 series telephone access systems and their networking capabilities.
Lists the main features and functionalities of the TX3 series products, including communication and access control.
Explains the process and importance of grounding the telephone access system to prevent electrical shock.
Provides an overview of the TX3 system, its networking capabilities (RS-485, Ethernet), and system types (ADC/NSL).
Explains connecting panels using a peer-to-peer RS-485 network, including address requirements.
Covers connecting panels using Ethernet TCP/IP networks, removing device limitations and introducing Master Nodes.
Details the layout and components of the main controller board, including connectors, potentiometers, switches, and jumpers.
Explains the various input/output connections on the bottom side of the controller board, such as microphone and inputs.
Describes the telephone line and output relay connections on the top side of the controller board, including door strike outputs.
Explains how to set the controller's unique ID and configure network settings using DIP switches.
Covers system configuration via PC using TX3 Configurator Software and procedures for updating firmware.
Outlines the initial steps for system configuration, including verifying components and network settings.
Explains how to add other controllers (Card Access, Elevator Restriction) to the TX3 system via RS-485 or Ethernet.
To Next Page
