MBD-2 Operating Manual 11
15-00167, Rev 1
4.3 Batteries
4.3.1 Removal/Replacement of the Main Battery
4.3.1.1 Main Battery Replacement
a. Prior to replacing the battery, remove the wristband from at least one C-Ring so that the
battery cover is accessible.
NOTE: Battery change should not take place under direct rain-like conditions as water inside
the battery compartment may cause premature battery discharge.
b. Turn the battery cover counter-clockwise to remove.
Figure 8: MBD-2 Battery Cover Removed
c. Verify the presence of the O-Ring. Inspect for integrity. See Section 6, Maintenance, for
additional O-Ring information.
Figure 9: O-Ring Location
d. Remove the main battery
e. Dispose the used battery in accordance with site requirements.
To Next Page
Loading...
