Mirion Technologies MBD-2 - Figure 20: C-Ring Removal; Figure 21: C-Ring Replacement

MBD-2 Operating Manual 21
15-00167, Rev 1
a. Obtain a Snap-Ring plier or similar tool that will facilitate easy removal of the C-Ring. The
adjustable tines on the Snap-Ring plier tool should be extended to allow expansion, when
squeezed, so that it will be slightly wider than the width of the C-Ring.
b. Lift one end of the ring from the insertion hole and angle away to remove the C-Ring as
shown in Figure 3-3: MBD C-Ring Removal.
Figure 20: C-Ring Removal
c. To replace the C-Ring, grip the loose C-Ring with the Snap-Ring plier tool. Ensure that
when squeezing the Snap-Ring plier tool, the width of the C-Ring will be slightly wider than
the case to facilitate easy replacement as shown in Figure 21: C Ring Replacement.
d. Position one side of the C-Ring into the insertion hole, then the other side.
e. Release the Plier tool so that the C-Ring is now secure.
f. Swivel the C-Ring to ensure fit.
Figure 21: C-Ring Replacement