MBD-2 Operating Manual 12
15-00167, Rev 1
Figure 10: MBD-2 Battery Compartment and Markings
f. The battery compartment features imprints of battery orientation and model number.
g. Insert a new battery (Model CR2450, Renata brand preferred) into the compartment,
positive (+) side facing up, as shown below in Figure 11, MBD-2 Correctly Installed
Battery Position.
Figure 11: MBD-2 Correctly Installed Battery Position
h. Confirm the presence of the O-ring prior to installing the battery cover. Ensure the O-Ring
is not twisted, warped or worn and that it lays flush on the surface flange. Refer to
Section 6.1, O-Ring for guidance.
i. Install the battery cover by turning clockwise.
The MBD-2 case and battery cover are designed with thread stops, as shown below in
Figure 12, MBD-2 and Main Battery Cover Thread Stop, to prevent wear and stripping
of the threads and also ensure a secure fit.
When installed and turned clockwise, the battery cover will stop in place when the thread-
stop is engaged.
Battery Orientation:
Positive (+) Side Up
Battery Model: CR2450N
(Renata brand recommended)
To Next Page
Loading...
