Operation Manual ____________________Safety – Warnings and Precautions
_________________________________________________________________________________________________
1-1
1. SAFETY - WARNINGS AND PRECAUTIONS
Read ALL Instructions Before Installing or Using Equipment
Your new Ultrasonic Liquid Processor has been designed, built and tested to assure
maximum operator safety. However, no design can completely protect against improper
usage which may lead to bodily injury and/or property damage. For total safety and
equipment protection, read the instruction manual carefully before attempting to operate
this equipment. Observe the following WARNINGS:
• High voltage is present in the generator (power supply), convertor and high frequency cable.
There are no user-serviceable parts inside any of these devices. Do NOT attempt to
remove the generator cover or convertor case.
• Do NOT touch any open cable connections on the unit while the power is turned ON.
• Do NOT operate generator with convertor disconnected from high voltage cable. High
voltage is present in the cable and may pose a shock hazard.
• The generator must be properly grounded with a 3-prong plug. Test electrical outlet for
proper grounding before plugging in unit.
• Install the SONICATOR
®
in an area free from excessive dust, dirt, explosive or corrosive
fumes and protected from extremes in temperature and humidity.
• NEVER immerse the convertor in liquids of any kind, or let condensed moisture or liquid drip
into the convertor.
• NEVER grasp an activated horn or touch the tip of a vibrating probe. It can cause severe
burns and tissue damage.
• NEVER hold or clamp the convertor by the front driver (black portion) or by the horn itself.
This can cause permanent damage to the system. Support the convertor by clamping only
around the broad (chrome) section.
• Do NOT allow the tip of a vibrating horn or probe touch the counter top or any other hard
surface. It could damage the probe or overload the generator.
• Avoid touching the bottom or sides of a glass or plastic container with a vibrating probe. It
could crack or shatter the glass or melt the plastic.
• Turn OFF the power switch, unplug the generator and disconnect the power cord from the
back of the generator before attempting to replace the fuse.
To Next Page
Loading...