Mitel 5324 Guide

7
provided).
Use the slot behind the plastic cover at the bottom of the phone
to remove/insert the designation card.
u Handsfree Speaker
Provides sound for Handsfree calls and background music.
v Handset
Use for handset calls. If you are in headset or handsfree mode,
you do not need to use the handset.
Ring/Message Indicator
When indicator is… it means that…
Flashing rapidly Your phone is ringing
Flashing slowly A Message or Callback Message is waiting at your phone
On
Your phone is ringing another phone
Off
Your phone is idle, or you are on a call
About Feature Access Codes
Use of some features requires dialing access codes. The codes are flexible and may be
different than those in this guide. Ask your Administrator for a list of codes you should use.
For Users on Resilient 3300 ICP Systems
If during a call, you hear two beeps that is repeated every 20 seconds it means that your
phone is switching to a secondary 3300 ICP system. The call continues but some of the
keys and features on your phone function differently. The keys and features begin
working normally again after you hang up. If your phone switches to the secondary
system while your speaker or handset is muted (that is, while the
MUTE key light is
on), the call remains muted until you hang up. Normal operation resumes when your
phone switches back to the primary system. If your phone is idle and switched to the
secondary system, you'll see a flashing rectangle on the display. The rectangle remains
until the switch to the primary system is complete.
IP Phone and Line Interface Module
The Line Interface Module is an optional device that adds an analog phone line (POTS)
capability to your 5224/5324 IP Phone. If Emergency Call Routing is not programmed on
your 3300 ICP, you must use the Line Interface Module to dial emergency calls. For
more information on emergency number dialing, refer to Emergency Calls.
If you have a Line Interface Module connected to your 5224/5324 IP Phone, all
programming of the Line Interface Module, except the Analog Key, is done by the
Installer when your phone is installed. For more information, refer to “Using the Line
Interface Module” in this guide.

Mitel 5324 Specifications

Processor and Memory

processor type	TNETV1055 (MIPS)
processor speed	125 MHz
DSP speed	165 MHz
RAM	16 MB
ROM	8 MB

Weight and Dimensions

dimensions (phone only)	9.1 in x 7.5 in x 3.5 in (23 cm x 19 cm x 9 cm)
weight (phone only)	1.65 lbs or 0.75 kg
dimensions (packaged)	9.8 in x 8.3 in x 3.9 in (25 cm x 21 cm x 10 cm)
weight (packaged)	2.49 lbs or 1.13 kg