Configuration
Note:
There is no access log for the SMB Controller Manager.
5.6 WebAdmin remote access
With a remote maintenance access the user is authenticated using his user name and password. The user
account must also be assigned an authorization profile in which the interface access Remote maintenance
dial-up access is enabled. This also applies to SRM (Secure IP Remote Management), secure IP remote
management.
5.6.1 Access enabled by local users
Remote maintenance access can be enabled in two ways:
• Using function codes (see Function code for remote maintenance access)
• With WebAdmin
It can be revoked again automatically or manually.
All enabling types have equal authorization status. This means that remote maintenance access can
be enabled using a function code for example, and then barred again using the WebAdmin in general
maintenance settings.
When remote maintenance access is activated, the event message Remote maintenance on is sent to all
message destinations where the corresponding filter criteria in the assigned event table is set accordingly
(see chapter Event tables).
If remote maintenance is released, this can be recognised in the WebAdmin title bar of the symbol.
Remote maintenance access can be enabled or barred using the function codes both from the idle state
and the talk state, e.g. after an enquiry.
The authorisation to activate or bar remote maintenance access using the function code is defined and
granted to the user with the parameter Remote maintenance access in a permission set.
After a first start of the communication server, the authorizations of all users are restricted.
Release 7.1
System Manual for Mitel SMB Controller 184
To Next Page
Loading...
Need help?
General
