4. Restart the phone.
The phone searches for the communication server. If more than one communication server is available,
the phone lists them in the format lt;XXX–MAC address>.
5. Choose your communication server from the list, and when prompted, enter the Registration user name
and the Registration password.
The phone registers with the communication server. If a new phone software is available, the phone
automatically updates and restarts.
Connect the digital system phones MiVoice 5300
1. Add one ore more expansion key module(s) to the phones.
2. Connect the phones to the DSI interfaces on the front panel. Connect the phones in the same order as
you have set them up in the previous chapter and start with the lowest port number.
3. The phones are registered and allocated to their phone data instance in the communication server. If
you keep the suggested order, the phone type matches with the configured terminal type. You can fix a
terminal mismatch in the WebAdmin terminal view.
Test your configuration
Now you are able to make internal calls between the phones you connected to your communication server.
Do some calling tests between the different phone types and check the audio. In the document center, you
can find the user’s guides to your phones.
2.7.3.7 Make further configurations
Congratulations, you have set up the communication server for self training purposes. Now you have a
perfect configuration platform to learn more about the communication server, its features and expansion
possibilities.
For further configurations, use the WebAdmin configuration assistant and the online help. For detailed
information, see the user’s guides and system manuals on Document Centre.
To Next Page
Loading...
Need help?
General
