3.3 SYSTEM DEPENDENT PHONE SETTING
Message Waiting Memory (MWM)
There is a message waiting memory in the telephone where the number to the voicemail box shall be
stored.
Save MWM
1. Place the handset on the phone and press
2. Press and enter the number to be saved
3. Press key again to complete saving
Dial from a MWM
1. Pick up the handset or press ‘Speaker/Handset’
2. Press the
Message Waiting LED
When there is a message, the message waiting LED will be lighted ON or flashing in blue.
The Message Waiting switch (at the back of the phone) is used to select the appropriate MW mode
(HV / + / -). Please check which MW type the PBX system supports. Select “OFF” on the MW switch to
deactivate the message waiting function.
If the LED is steady active, change the message waiting switch position.
Set Flash time
Some systems require a different flash time for the flash key. To change the flash time, proceed as
follows:
1. Press # 0 1 # X #
where X is the flash time value between 1 and 9. See table below
Parameters Programming key sequence Lock
Protected
To Next Page
Loading...
