20
EX Controller Installation Guide
HARDWARE INSTALLATION
BEFORE YOU BEGIN
Note or take a picture of your unit's serial number before starting the installation,
and place the card stickers of the cards not factory installed. Refer to Locating the
Product Serial Number.
INSTALLING THE UNIT ON A FLAT SURFACE
BEFORE YOU START
Steps
1. Unpack the unit and go through the Package Check List
2. Apply the Bumpon™ autoadhesive protective products to the bottom
of the unit.
3. Install the unit on the flat surface.
4. Make sure the unit is at 20 cm (8 in.) from your monitor, computer
casing, or other peripheral, including speakers.
WARNING: Before performing this procedure, you must first
read and understand the Safety Recommendations listed in
this document.
Note: This will improve the airflow under the unit.