Appendix 1. Cable and Connector Specifications
A1 - 19
(8) Tightening a clamp nut
[1] Temporarily tighten the clamp nut on the back shell.
* To prevent loosening, the adhesive should be applied to the back shell.
[2] Set the clamp nut wrench on the clamp nut.
[3] With the wrench, tighten the clamp nut on the straight back shell.
Recommended tightening: 5Nm
(Note) Accurately fit the wrench on the clamp nut.
To remove, take the reverse steps.
* Recommendation
Adhesive (2 threads around
the circumference)
Temporary tightening
Set
Tightening guide
Torque wrench
Tighten
Clamp nut
wrench
19
17
* Referential dimensions for back
shell tightening guide
(Back shell width)
20
Thickness
:10
* Recommendation :
Tightening guide
(357J-50494T)
● Recommended jigs and tools : Clamp nut wrench(357J-51334T)
Bit (357J-51345T)
Torque wrench (CL6N x 8D, Tonichi Mfg.)
* Recommended tightening jig : (357J-50494T)
Back shell
Clamp nut
Tightening guide
* Recommended adhesive : Screw lock 1401B (Three Bond Co,.Ltd)
Downloaded from ManualsNet.com search engine
To Next Page
Loading...
