Mitsubishi Electric MELSEC iQ-F Series - Page 43

5 CHECKING OPERATIONS
5.1 Checking the Operation of Connect (MQTT Connection Establishment)
42
5
Program
M12 turns on for setting the information used for M+ENET_MQTT_Connect (MQTT connection establishment).
M12
K1 D0
D1
D2
D3
D4
D6
MOV
MOV
K60MOV
K0
K30
MOV K300
K0MOV
MOV
MOV
K0 D5
R600$MOV MQTT_TEST/topic/name
R300$MOV MQTT_TEST Will message
R0$MOV MQTT_TEST/Will/Topic/Name
SM402
Set the connection number to K1.
Set the timeout value to K30.
Set the KeepAlive timer to K60.
Set Will QoS to K0.
Set the Will message data start address to K300.
Set the Will topic/message format to K0.
Set the Will topic name data start address to K0.
Set the Publish/Subscribe topic name data for R600.
Set the Will message data for R300.
Set the Will topic name data for R0.