Mitsubishi Electric MELSEC iQ-R Series - Page 148

146
5 SAFETY APPLICATION CONFIGURATION EXAMPLES
5.2 System to Which Multiple Safety CPUs are Connected
Setting system parameters
Parameters can be set from [Module Configuration] to be displayed by double-clicking "Module Configuration" in [Navigation
window]. Parameters can be set by allocating modules according to the configuration to be used. Before setting parameters,
select a main base unit from the "Element Selection" window and drag and drop it to the "Module Configuration" window.
Then, place the required modules on the main base unit. The Safety CPU set when creating the project is displayed since the
beginning at the module configuration. Allocate the safety function module from the "CPU extension" in the [Element
Selection window].
Allocate program elements in the chart below, based on the following, and determine the parameters. Then, select [Tool] 
[Check Parameter] from menu and check set parameters.
Window
Displayed items
Number Module Model
(1) Main Base Unit R35B
(2) Power Supply R61P
(3) Safety CPU This is a model name of the Safety CPU.
(4) CPU extension R6SFM
(5) Network Module RJ71GF11-T2
(6) Network Module RJ71GF11-T2
(1)
(2) (3) (4) (5)
(6)