Mitsubishi Electric MELSEC iQ-RJ71C24-R4 - Initial Settings of Serial Communication Module

174
7 COMMUNICATIONS BY THE MODEM FUNCTION
7.4 Startup of the Modem Function
Initial settings of Serial communication module
This section explains the initial settings of C24 for data communication with a target device by using the modem function.
Communication protocol setting, Communication speed setting, Transmission setting
Setting item Data communication
Test mode setting No specification
Communication protocol setting • MC protocol (Formats 1 to 5)
• Nonprocedural protocol
• Bidirectional protocol
Communication speed setting (Set according to modem/TA on the host station)
Transmission setting Operation setting Independent
Data bit (Set according to modem/TA on the host station)
Parity bit
Odd/even parity
Stop bit
Sum check code (Set according to system specification)
Online change
Setting change
Station number setting (CH1, 2 in common: 0 to 31) 0 to 31