G
grahamcharlesAug 31, 2025
What causes a control process error in Mitsubishi Electric MELSERVO-J4 Amplifier?
- ZzjonesSep 1, 2025
A control process error in your Mitsubishi Electric Amplifier can be due to control process errors 1 through 10.
To Next PageTo Next PageWhat causes a control process error in Mitsubishi Electric MELSERVO-J4 Amplifier?
A control process error in your Mitsubishi Electric Amplifier can be due to control process errors 1 through 10.
What does an absolute position erased error mean on Mitsubishi Electric MELSERVO-J4 Amplifier?
An 'absolute position erased' error in your Mitsubishi Electric Amplifier indicates that the absolute position has been erased from either the servo motor encoder or the scale measurement encoder.
What causes an encoder initial communication error 1 in Mitsubishi Electric MELSERVO-J4 Amplifier?
An encoder initial communication error 1 in your Mitsubishi Electric Amplifier may be due to: * Receive data errors 1, 2, or 3. * Transmission data errors 1, 2, or 3. * Process errors 1, 2, 3, 4, 5, or 6.
What does an encoder initial communication error 3 mean on Mitsubishi Electric MELSERVO-J4 Amplifier?
An encoder initial communication error 3 on your Mitsubishi Electric Amplifier indicates an incompatible encoder or an incompatible load-side encoder.
What causes CC-Link IE communication error on Mitsubishi Electric Amplifier?
General| Series | MELSERVO-J4 |
|---|---|
| Full-closed Control | Supported |
| Advanced One-touch Tuning | Supported |
| Real-time Adaptive Tuning | Supported |
| Vibration Suppression Control | Supported |
| Communication Interface | SSCNET III/H |
| Safety Functions | STO (Safe Torque Off), SS1 (Safe Stop 1), SS2 (Safe Stop 2), SBC (Safe Brake Control) |
| Protection Functions | Overcurrent, Overvoltage, Overload, Overheat, Encoder Error, Regenerative Error |
| Ambient Temperature | 0°C to +55°C |
| Vibration Resistance | 5.9 m/s² (0.6G) at 10 to 55 Hz |
| Feedback System | Absolute/Incremental Encoder, Resolver |
