Mitsubishi Electric Q13UDVCPU - Page 312

310
1005
[MAIN CPU DOWN]
Runaway or failure of the CPU module
• Malfunction due to noise or other causes
• Hardware failure
■Collateral information
• Common information: -
• Individual information: -
■Diagnostic timing
• Always
• Take noise reduction measures.
• Reset the CPU module and run it again. If
the same error code is displayed again, the
cause is a hardware failure of the CPU
module. Please consult your local
Mitsubishi representative.
RUN: Off
ERR.:Flashing
CPU Status:Stop
QCPU (except
QnUDV)
[MAIN CPU DOWN]
Boot operation was performed in the transfer
destination without formatting.
■Collateral information
• Common information: -
• Individual information: -
■Diagnostic timing
• At power-on
Before performing boot operation by the
parameter, select "Clear program memory" to
clear the program memory.
Qn(H)
QnPH
QnPRH
[CPU UNIT DOWN]
Runaway or failure of the CPU module
• Malfunction due to noise or other causes
• Hardware failure
■Collateral information
• Common information: -
• Individual information: Failure information
■Diagnostic timing
• Always
• Take noise reduction measures.
• Reset the CPU module and run it again. If
the same error code is displayed again, the
cause is a hardware failure of the CPU
module. Please consult your local
Mitsubishi representative.
LCPU
1006
[MAIN CPU DOWN]
Runaway or failure of the CPU module
• Malfunction due to noise or other causes
• Hardware failure
■Collateral information
• Common information: -
• Individual information: Failure information
(QnUDVCPU only)
■Diagnostic timing
• Always
• Take noise reduction measures.
• Reset the CPU module and run it again. If
the same error code is displayed again, the
cause is a hardware failure of the CPU
module. Please consult your local
Mitsubishi representative.
RUN: Off
ERR.:Flashing
CPU Status:Stop
QCPU
[CPU UNIT DOWN]
Runaway or failure of the CPU module
• Malfunction due to noise or other causes
• Hardware failure
■Collateral information
• Common information: -
• Individual information: Failure information
■Diagnostic timing
• Always
LCPU
1007
[MAIN CPU DOWN]
Runaway or failure of the CPU module
• Malfunction due to noise or other causes
• Hardware failure
■Collateral information
• Common information: -
• Individual information: -
■Diagnostic timing
• Always
• Take noise reduction measures.
• Reset the CPU module and run it again. If
the same error code is displayed again, the
cause is a hardware failure of the CPU
module. Please consult your local
Mit
subishi representative.
RUN: Off
ERR.:Flashing
CPU Status:Stop
Qn(H)
QnPH
QnPRH
1008
[MAIN CPU DOWN]
Runaway or failure of the CPU module
• Malfunction due to noise or other causes
• Hardware failure
■Collateral information
• Common information: -
• Individual information: Failure information
(QnUDVCPU only)
■Diagnostic timing
• Always
• Take noise reduction measures.
• Reset the CPU module and run it again. If
the same error code is displayed again, the
cause is a hardware failure of the CPU
module. Please consult your local
Mitsubishi representative.
RUN: Off
ERR.:Flashing
CPU Status:Stop
Qn(H)
QnPH
QnPRH
QnUDV
Error
code
Error and cause Corrective action
LED status,
CPU status
Corresponding
CPU